CostGuide.ca

What home projects cost in Alberta

For contractors

How much does hardwood flooring cost in Edmonton?

Hardwood flooring in Edmonton costs $8 to $15 per square foot installed, one Edmonton installer reports. Another prices engineered hardwood at $8 to $14 and solid hardwood at $10 to $23 before GST. Species, board type, stairs and the state of the subfloor move the price most.

By the CostGuide.ca editorial team. Published 29 October 2026. Prices checked October 2026 against 8 sources.

Get a quote from a local flooring installer

How much do engineered and solid hardwood cost in Edmonton?

An Edmonton installer prices engineered hardwood at $8 to $14 per square foot installed and solid hardwood at $10 to $23 before GST, so solid has the far higher ceiling.

Edmonton hardwood flooring prices

Low to high range

JobLowHigh
Hardwood, installed$8 to $15per sq ft $8 $15
Engineered hardwood, installed$8 to $14per sq ft. Before 5% GST $8 $14
Solid hardwood, installed$10 to $23per sq ft. Before 5% GST $10 $23
Domestic hardwood (oak, maple, hickory), material only$7 to $12per sq ft. From a December 2024 article; exotic species cost more $7 $12
Hardwood installation, labour only$4 to $10per sq ft. From a December 2024 article $4 $10
New hardwood in place of an old floor, installed$10 to $15per sq ft. From a December 2024 article; the store says this could run higher $10 $15

Prices in CAD as local contractors publish them. Most do not say whether 5% GST is included, so ask for GST as its own line. Alberta has no PST. Checked October 2026.

Three Edmonton businesses publish hardwood figures: two flooring installers and a flooring store. One installer splits engineered and solid boards and states its prices are before 5% GST. The other installer gives one installed range. The store, in an article from December 2024, breaks out material and labour and compares refinishing with a new floor.

Solid hardwood's top price is far above engineered's, and the installer's own breakdown shows both the boards and the labour cost more for solid. The store puts hardwood labour alone at $4 to $10 per square foot. If the floor is one part of a larger refresh, the Edmonton renovation cost guide covers the bigger picture.

Want a real number for your hardwood floor?

What do you need?

What will hardwood cost for my floor in Edmonton?

Pick a board type and enter the area. An Edmonton installer prices engineered hardwood at $8 to $14 per square foot before GST.

Enter your floor area in sq ft.

Uses installed rates per square foot from two Edmonton installers. Removal, levelling, stairs and baseboards are extra. A guide only, not a quote.

What does a full hardwood job cost in Edmonton?

An Edmonton installer prices engineered hardwood across a 1,000 sq ft main floor at $9,000 to $14,000 and a 13 to 15 step hardwood staircase at $3,200 to $3,800, both before GST.

Edmonton hardwood job examples and extras

Low to high range

JobLowHigh
Engineered hardwood on a 1,000 sq ft main floor$9,000 to $14,000per project. Before 5% GST $9,000 $14,000
Hardwood stairs, 13 to 15 steps$3,200 to $3,800per staircase. Before 5% GST $3,200 $3,800
Stairs in hardwood or laminate$45 to $75per step. Before 5% GST $45 $75
Removing existing flooring$1 to $5per sq ft. Before 5% GST $1 $5
Subfloor levelling, affected area only$1 to $5per sq ft. Before 5% GST $1 $5
Herringbone or diagonal layout, extra$1 to $2per sq ft. Before 5% GST $1 $2
New baseboards, installed$2 to $4per linear ft. Before 5% GST $2 $4

Prices in CAD as local contractors publish them. Most do not say whether 5% GST is included, so ask for GST as its own line. Alberta has no PST. Checked October 2026.

Is refinishing cheaper than new hardwood in Edmonton?

Yes: an Edmonton flooring store puts refinishing at $3 to $7 per square foot, against $10 to $15 or more for new hardwood.

Edmonton refinishing against new hardwood

Low to high range

JobLowHigh
Hardwood floor refinishing$3 to $7per sq ft. From a December 2024 article $3 $7
New hardwood in place of an old floor, installed$10 to $15per sq ft. From a December 2024 article; the store says this could run higher $10 $15

Prices in CAD as local contractors publish them. Most do not say whether 5% GST is included, so ask for GST as its own line. Alberta has no PST. Checked October 2026.

Should you pick engineered or solid hardwood in Edmonton?

Engineered hardwood costs less and can go in places solid boards should not, such as over concrete, while solid hardwood costs more but gives the most sanding over its life.

Engineered

$8 to $14 per square foot installed before GST. Mirage, a Canadian maker, says its engineered floors can be glued down over concrete that provides 3000 psi. [2] [7]

Solid

$10 to $23 per square foot installed before GST. The same maker advises against its 3/4 inch solid boards over concrete, and its specification lists solid floors as nailed or stapled down above and on grade. For a basement, see the Edmonton basement development guide. [2] [7] [8]

Species

Domestic hardwoods such as oak, maple and hickory cost $7 to $12 per square foot for the material alone, an Edmonton store says, and exotic species cost more. [3]

When can an Edmonton hardwood floor be refinished instead of replaced?

Most hardwood can be refinished 5 to 10 times, an Edmonton installer says, unless damage goes through the wear layer, water has cupped the boards or an engineered board's wear layer is under 2 mm.

  • How often. An Edmonton flooring store says that, depending on use, you may need to refinish every 7 to 10 years. [3]
  • When it will not work. Deep gouges into the wood structure, water damage that causes cupping or buckling, boards sanded too many times, and engineered floors with a wear layer under 2 mm. [6]
  • Back in use. New finish needs 24 to 48 hours before light foot traffic and 7 to 14 days to fully cure, the installer says. [6]

How do you protect hardwood through an Edmonton winter?

Keep indoor humidity steady within your floor maker's range; Mirage, a Canadian maker, says to keep relative humidity around 45% for best results.

  • Know your range. Mirage's specification for its solid hardwood says relative humidity must always stay within 35% to 55%. Other makers set their own range, so read your warranty. [8]
  • Before installation. Mirage suggests the boxes spend at least 24 hours in the room where the floor will go, with engineered and locking boxes left sealed. [7]
  • Wood stoves and fireplaces. Near a wood stove, Mirage says humidity must still be kept to the level its products need, which is 45% for solid and engineered boards. [7]

What should you check before hardwood goes in an Edmonton home?

Confirm the job needs no permit, check the installer's provincial licence before paying a deposit, and plan for any structural repairs under the floor separately.

Is a permit needed to lay hardwood in Edmonton?

No permit is needed just to replace flooring in Edmonton, according to the City's list of renovations (as at October 2026). Structural changes do need a permit, so repairing joists under a sagging floor is a separate job from laying the hardwood. [4]

Should I pay a deposit for hardwood in Edmonton?

Only to a licensed business. Alberta requires a prepaid contracting licence from businesses that sell to you away from their own premises and take money before all the work is done. Licensees must provide confirmation of their licence on request (as at October 2026). See deposits and licences for how to check. [5]

What should an Edmonton hardwood quote include?

An Edmonton hardwood quote should spell out the species, grade and board construction, how it will be fastened, removal and levelling, stairs, baseboards and 5% GST on a separate line.

  • Species and grade, with board width and thickness
  • Engineered or solid, and the wear layer for engineered boards
  • Nailed, glued or floating installation, and what goes under it
  • Removal of the old floor and disposal
  • Levelling, priced on the affected area
  • Stairs, priced per step or as a full staircase
  • Baseboards and transition strips
  • The maker's humidity range and warranty
  • 5% GST shown separately

Hardwood terms on an Edmonton quote

Wear layer
The real wood surface on an engineered board. An Edmonton installer says boards with a wear layer under 2 mm are not suitable for refinishing. [6]
Cure time
How long a new finish takes to harden fully. For refinished hardwood, an Edmonton installer gives 7 to 14 days. [6]
Glue-down
Fixing boards to the subfloor with adhesive instead of nails. Mirage says this is how its engineered boards can go over concrete. [7]

Edmonton hardwood floor questions

How much does 1,000 sq ft of engineered hardwood cost in Edmonton?

An Edmonton installer prices engineered hardwood on a 1,000 sq ft main floor at $9,000 to $14,000 before 5% GST. Removing the old floor, levelling, stairs and new baseboards are extra, so get those priced as their own lines.

How much do hardwood stairs cost in Edmonton?

An Edmonton installer charges $45 to $75 per step for hardwood or laminate stairs, and prices a full 13 to 15 step hardwood staircase at $3,200 to $3,800, both before GST.

Can engineered hardwood go over in-floor heating?

Many engineered floors can. Mirage, a Canadian maker, says its engineered and locking floors can be installed over radiant heat, except jatoba (Brazilian cherry) and hickory. If the heating is new electric wiring, Edmonton also requires an electrical permit.

Does hardwood cost more than laminate in Edmonton?

Yes. One Edmonton installer prices laminate at $4.30 to $8.00 per square foot installed and engineered hardwood at $8 to $14, both before GST. Laminate cannot be refinished, while hardwood can be sanded several times over its life.

Sources

  1. Vinyl Flooring Installation Cost in Edmonton: A Guide, LCF Flooring Ltd. (Edmonton flooring installer). Published 2025-08-30. Checked 2026-10-29.
  2. Flooring Installation Cost in Edmonton (2026 Guide), NorthEdge Flooring (Edmonton flooring installer). Published 2026-04-20. Checked 2026-10-29.
  3. Understanding the True Costs of Hardwood Flooring Beyond the Initial Price, Flooring Superstores Edmonton (flooring store). Published 2024-12-01. Checked 2026-10-29.
  4. Renovations and basement development, City of Edmonton. Checked 2026-10-28.
  5. Prepaid contracting licence, Government of Alberta. Checked 2026-10-28.
  6. Hardwood Floor Refinishing in Edmonton: How to Restore Your Floors Without Replacing Them, LCF Flooring Ltd. (Edmonton flooring installer). Published 2026-10-12. Checked 2026-10-29.
  7. FAQ: Installing hardwood floors, Mirage Hardwood Floors (Canadian hardwood maker). Checked 2026-10-29.
  8. General and technical specifications, solid hardwood (CAN 26_02), Mirage Hardwood Floors (Canadian hardwood maker). Checked 2026-10-29.

Hardwood, installed$8 to $15

Get a quote